LORENTZ Pumping Accessories

LORENTZ SunSwitch Light Sensor

Turns pump on/off when sunlight is adequate / inadequate. Can also be used in conjunction with Power Packs to establish back-up power once the sun is down.

Manual

LORENTZ Stilling Tube

Use the stilling tube to protect your pump from falling sediments in your well, and from solids that may be drawn upwards by pump suction. Dimensions: 33.25" x 5.0" O.D. x 4.5" I.D.

Instructions

Float Switch

Works in holding tank to turn off pump when tank is full, and back on when water level drops. Can be utilized in 'normally open' or 'normally closed' positions. Weight and cable tie included.

Low Water Sensor

Attached to the top end of the pump in your well and connected to your PS controller, this device turns off pump if water level is too low, and will return power after water recovery.

Pressure Switch Installation Kit

Regulates pump on/off based on pressure and can divert water to multiple sources. Usually used in conjunction with a pressure tank for home water pressurization with a BOOST pump. Pressure guage and pressure-relief valve are included in set-up. Pre-assembled.

Filter

It is necessary to remove sediments from your water before pumping with a BOOST pump.